Contents: Camber adjustment ⬇ Convergence adjustment ⬇
Camber adjustment
1. Loosen the nut (And in the illustration) upper wishbone mounts on the subframe and adjust the camber by turning the hex head of the eccentric bolt (B), then tighten the nut to 95 Nm.
20.1. Adjusting the rear wheel camber
Note: The maximum adjustment range is 90° in each direction.
2. After tightening the nut, check the camber again.
Convergence adjustment
3. Loosen the nut (1 in the illustration) and turn the eccentric bolt (2) until the required value is obtained, then tighten the nut with a force of 95 Nm.
20.3. Adjusting the toe-in of the rear wheels
(Data copied from the portal: SKODABOOK.ru)