Camber adjustment
1. Loosen the nut (And on the opposite illustrations) mounting the upper wishbone to the subframe and adjust the camber by turning the hex head of the eccentric bolt (IN), then tighten the nut to 95 Nm.
20.1 Rear camber adjustment
Note: The maximum adjustment range is 90°in each direction.
2. After tightening the nut, check the camber again.
Convergence adjustment
3. Loosen the nut (1 per resist. illustrations) and turn the eccentric bolt (2) until the required value is obtained, then tighten the nut with a force of 95 Nm.
20.3 Rear wheel toe-in adjustment