Brake system of the car Skoda Yeti

Brake system — specifications
General information Brake system type - Double diagonal split circuit Type and volume of brake fluid - see Specifications to Chapter 1 Maximum permissible pressure drop from 50 bar in 45 seconds¹, bar - 4 ABS/ESP...

General information and safety precautions
General information Depending on the vehicle modification. different brake mechanisms can be installed ( see Specifications ). The brake system is divided diagonally into two independent hydraulic circuits and consists...

Repair and maintenance of front brake mechanisms
Note: Brake pads should be replaced in pairs and on both wheels of the same axle at the same time. Note: If the pads are not being removed for replacement, i.e. will be reinstalled, mark them before removal so that they...

Repair and maintenance of rear brake mechanisms
1. The rear brake components are shown in the illustrations on the next page. 3.1a. Rear brake mechanism parts CII-41 (aWD models) 1, 7. Bolt, subject to replacement, 70 Nm, then tighten to an angle of 90°; 2. ABS...

Repair and maintenance of the parking brake
1. The parking brake parts are shown in the illustration. 4.1. Parking brake parts 1. Parking brake lever, remove the center console before removing ( see Chapter 11 ); 2. Nut, 20 Nm; 3. Tension pin; 4. Equalizer; 5....

Removal and installation the brake pedal, D/W brake lights and brake pedal position sensor
1. The brake pedal mounting parts are shown in the illustration. Before installation, lubricate all mounting points with polyurea grease G 052 142 A2. 5.1. Brake pedal mounting parts 1. Brake pedal bracket; 2....

Removal and installation of the brake master cylinder, vacuum booster and brake fluid reservoir
1. The parts of the brake master cylinder, brake booster and brake fluid reservoir are shown in the illustration. 6.1. Details of the brake booster unit, brake booster and brake fluid reservoir 1. Brake pedal with...

Removal and installation the vacuum pump and sensor G608, checking the non-return valve
1. Description of removal and installation of the vacuum pump is given in Sections 30 and 39 Chapters 2 . 2. Through a non-return valve (And in the illustration) air should flow only in the direction of the arrow. 7.2....

Removal and installation of the hydraulic modulator and ESP control unit
1. The installation details of the hydraulic and electronic control unit assembly are shown in the illustration. The assembly is located on the right side of the engine compartment bulkhead. Separation of the hydraulic...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Chassis (running gear): Brake system Skoda Fabia 2 (2007-2014)
➧ Chassis (running gear): Brake system Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Brake system Skoda Octavia 3 (2013-2019)
➧ Chassis (running gear): Brake system Skoda Superb 2 (2008-2015)
➧ Chassis (running gear): Brake system Skoda Kodiaq 1 (2016-2024)
➧ Chassis (running gear): Brake system Skoda Felicia (1994-2001)

Link to this section in various formats

TEXTHTMLBB Code

Yeti (2009-2017)