13.1. Installation details of the stabilizer of AWD models (fWD models - similar) 1. Stabilizer; 2. Support, replaceable on both sides at the same time; 3. Clamp; 4. Bolt to be replaced: on AWD models - 25 Nm, then tighten to an angle of 45°: on FWD models - 20 Nm, then tighten to an angle of 90°; 5. Hub assembly holder; 6. Self-locking nut, subject to replacement, 45 Nm; 7. Bolt; 8. Stabilizer link; 9. Subframe
2. Remove the rear wheels.
3. Give the nut (1 in illustration 10.34) and separate the anti-roll bar from its stand (2).
4. Check the stabilizer clamp bolts (see illustration 10.35).
5. Installation is carried out in reverse order. Tighten the clamp bolts evenly with the suspension unloaded.