Diesel engine 2.0L (CFHC/CFJA/CLCB) of car Skoda Yeti

Removal and installation of the engine and powertrain supports
Removal and installation Note: The engine is removed from underneath the engine compartment downwards together with the transmission. All removed electrical wiring ties and clamps must be in their original places during...

Removal and installation the accessory drive belt, its tensioner, auxiliary bracket and crankshaft pulley
1. The details of the auxiliary drive installation are shown in the illustration. 35.1. Auxiliary drive components (using the example of models with a compressor) 1. Crankshaft pulley; 2. Bolt, 25 Nm; 3. Generator; 4....

Removal and installation the timing belt, setting the timing phases
1. Timing belt and engine bracket installation details are shown in the illustration. 36.1. Timing Belt Installation Details 1. Timing belt; 2. Gear wheel mounting bolt 3, subject to replacement, 120 Nm, then tighten to...

Removal and installation of some parts related to the crankshaft
1. The installation details of the crankshaft oil seals, their sealing flanges and some related components are shown in the illustration. 37.1. Installation details of crankshaft oil seals, their sealing flanges and...

Removal and installation the cylinder head cover
1. The cylinder head cover installation details are shown in the illustration. 38.1. Cylinder head cover installation details 1. Gasket; 2. Cylinder head cover; 3, 14, 16. Sealing ring, subject to replacement; 4. PCV...

Removal and installation the cylinder head, vacuum pump and CMP sensor
Note: When removing the cylinder head, the engine temperature must not exceed 35°C, otherwise the cylinder head may become deformed after its bolts are loosened. 1. The installation details of the cylinder head, vacuum...

Work with the gas distribution mechanism
1. The design of the timing belt is shown in the illustration. Note: A cylinder head with cracks between the valve seats can be used without reducing the service life of the engine if these cracks are not too large and...

Work with lubrication system and balance shafts
1. The installation details of the oil pan and oil pump are shown in the illustration. 41.1. Oil pan and oil pump installation details 1. Bolt, 15 Nm; 2. Front sealing flange; 3. Oil pump drive belt; 4, 10. Bolt, 10 Nm;...

Features of engine overhaul
Note: The presence of metal shavings or large quantities of small metal particles found during engine rebuild may indicate damage to the crankshaft and connecting rod bearings. To prevent further damage, thoroughly...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Diesel engines Skoda Rapid 1 (2012-2022)
➧ Power unit: Diesel engines 2.0 l Skoda Superb 2 (2008-2015)
➧ Power unit: Diesel engine 2.0 l Skoda Kodiaq 1 (2016-2024)
➧ Power unit: Diesel engine Skoda Felicia (1994-2001)

Link to this section in various formats

TEXTHTMLBB Code

Yeti (2009-2017)