Removal and installation of the fuse block Fuse box in the instrument panel Additional battery pack Most car electrical circuits are protected by fuses. If any of the electrical devices on the car does not work, first check the fuse protecting the circuit of...
Battery — removal and installation Battery mount 1 - bolt; 2 - bracket; 3 - holder Battery holder mount 1 - holder; 2 - nuts; 3 - bolt Removal and installation 1. Push plastic loops 2 aside (see fig. V paragraph 1 of subsection 1.52 ) and open fuse box 1...
Removal and installation of a combination of devices Removing the instrument cluster 1 - screws; 2 – a combination of devices; 3 - bottom lining The instrument cluster cannot be repaired. Replace the faulty instrument cluster as an assembly. 1. Disconnect the wire from...
Replacing lamps in lighting devices High and low beam lamps Removing the headlight cover 1 - retainer; 2 - cover High Beam Bulb Replacement 1 - connecting block; 2 - lamp; 3 - spring retainer The location of the lamps in the headlight 1 - high beam lamp;...
Removal and installation of a headlight Headlamp top mount 1 - bolts; 2 - headlight Lower headlight mount 1 - bolt; 2 - headlight 1. Disconnect the wire from the terminal «-» battery. 2. Remove the front buffer. 3. Disconnect the headlight connector from the...
Removal and installation of a back lantern Removing the rear light 1 - lantern; 2 - latches; 3 - lamp holder; 4 - connecting block; 5 - nuts 1. Disconnect the wire from the terminal «-» battery. 2. Open the trunk and flip up the edge of the upholstery to access...
Replacement of an additional lantern of a signal of braking Removal of an additional lantern of a signal of braking 1 - bolts; 2 - lantern; 3 - connecting block The additional brake light has LEDs instead of bulbs. 1. Disconnect the wire from the terminal «-» battery. 2. Open...
Removal and installation of sound signals Removing sound signals 1 - sound signal; 2 - nut 1. Disconnect the wire from the terminal «-» battery. 2. Remove the left ventilating and average decorative lattices of the forward buffer. 3. Loosen nut 2 (see fig....
Removing and installing speakers Radio equipment installation diagram 1 - radio receiver; 2 - front tweeter; 3 - antenna; 4 - rear low-frequency speaker; 5 - rear high-frequency speaker; 6 - front woofer Front woofer Front woofer mount Attachment...
Removing and installing the antenna Antenna details 1 - antenna; 2 – antenna base; 3 - wire to the radio; 4 - wire to the telephone; 5 - nut; 6 - roof panel 1. Disconnect the wire from the terminal «-» battery. 2. Lower the rear headlining. 3. Disconnect...