Car power steering gear Skoda Fabia 1

Power steering gear design
EPHS power steering diagram (Electrically Powered Hydraulic Steering) 1 – steering gear housing; 2 – power steering sensor; 3 – steering column; 4 – instrument cluster control unit; 5 – speed sensor; 6 – engine control...

Replacing the tie rod end
Replacing the tie rod end is similar to replacing the tie rod end on models with a non-power steering system (see subsection 8.4.1 ).

Removal the steering gear
Hydraulic power steering components 1 – pumping unit; 2 – power steering sensor wire; 3 – return line; 4 – holder; 5 – steering gear housing; 6 – power steering sensor; 7 – pressure main; 8 – holder; 9 – receiver cover...

Installing the steering gear
Steering gear parts (with amplifier) 1 – tip; 2 – lock nut; 3 – outer clamp; 4 – protective cover; 5 – inner clamp; 6 – bolt; 7 – heat-insulating screen; 8 – steering rod; 9 – pillow; 10 – mounting bracket; 11 – seal;...

Replacing the steering rod
Disconnecting the steering rod from the rack (with amplifier) 1 – steering gear housing; 2 – rack; 3 – cap nut; 4 – steering rod 1. Remove the steering gear from the vehicle (see subsection 8.5.2 ). 2. Clean the...

Pump unit — inspection and replacement
Location of the air conditioner fan control unit 1 – control unit; 2 – bracket; 3 – nut; 4, 5 – connecting blocks Removal the wire and lines from the holder 1 – holder; 2 – return line; 3 – pressure main; 4 – power...

Checking the electrical circuits of the power steering
Designations of the contacts of the connecting blocks a – CAN-BUS Low; b – CAN-BUS High; in - reserve; g – "15"; d – "30"; e – "mass"; 1 – CAN-BUS connection block; 2 – power supply connection block 1. Check the...

Replacing the power steering sensor
1. Disconnect the wire from the "-" terminal of the battery. 2. If necessary, remove the air filter (see subsection 4.1 ). 3. Remove wire 2 (see figure Hydraulic power steering components ) power steering sensor from...

Replacing power steering lines
1. For ease of operation, remove the front buffer. 2. Unscrew cover 9 (see figure Hydraulic power steering components ) receiver and through the filler neck, remove the working fluid from the receiver using a rubber...

Checking the working fluid level
Receiver cap with liquid level indicator A – top mark; B – bottom mark Caution! Check the fluid level in the power steering hydraulic system receiver when the engine is cold. Caution! Do not reuse the fluid from the...

Filling and bleeding the hydraulic system
Caution! Fill the hydraulic power steering system only when the engine is cold. Caution! Do not reuse the fluid from the system: it is contaminated and saturated with air and moisture. Caution! Use only fluids...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code

Fabia 2 (2007-2014)