Car front suspension Skoda Fabia 1
Removal and installation a telescopic stand
Ball joint mounting 1 – front suspension arm; 2 – bolt; 3 – ball joint Front suspension strut parts 1 – steering knuckle; 2 – nut; 3 – tie bolt; 4 – shock absorber strut; 5 – compression buffer; 6 – protective cover; 7...
Ball joint mounting 1 – front suspension arm; 2 – bolt; 3 – ball joint Front suspension strut parts 1 – steering knuckle; 2 – nut; 3 – tie bolt; 4 – shock absorber strut; 5 – compression buffer; 6 – protective cover; 7...
Repair of a telescopic stand
The defective shock absorber strut must be replaced. Replacement 1. Open the hood, remove the protective cap and loosen the nut, holding the rod from turning with a hex key. After this, remove the rack from the car. 2....
The defective shock absorber strut must be replaced. Replacement 1. Open the hood, remove the protective cap and loosen the nut, holding the rod from turning with a hex key. After this, remove the rack from the car. 2....
Replacing the ball joint
Ball joint marking Letter L is the left support, R is the right one; the number 3 indicates that the support is used on models with 13-inch wheels, and the number 4 indicates that it is used on models with 14-inch...
Ball joint marking Letter L is the left support, R is the right one; the number 3 indicates that the support is used on models with 13-inch wheels, and the number 4 indicates that it is used on models with 14-inch...
Removal and installation the front suspension arm
Caution! When installing the front suspension arm, you must use a new bolt to secure the arm to the beam. Caution! If the rubber-metal hinge of the lever is damaged, replace the lever assembly with the hinge. Attaching...
Caution! When installing the front suspension arm, you must use a new bolt to secure the arm to the beam. Caution! If the rubber-metal hinge of the lever is damaged, replace the lever assembly with the hinge. Attaching...
Removal and installation the front suspension bracket
Fastening the stabilizer cushion clip 1 – bracket; 2 – bolts Fastening the strut to the anti-roll bar 1 – nut; 2 – barbell; 3 – rack Fastening the steering gear to the front suspension beam 1 – bolt; 2 – front...
Fastening the stabilizer cushion clip 1 – bracket; 2 – bolts Fastening the strut to the anti-roll bar 1 – nut; 2 – barbell; 3 – rack Fastening the steering gear to the front suspension beam 1 – bolt; 2 – front...
Replacing the rubber-metal support
Installing a rubber-metal support into a beam bracket 1 – protrusion on the support; 2 – mark on the bracket The rubber-metal support can be replaced without removing the front suspension beam bracket from the vehicle....
Installing a rubber-metal support into a beam bracket 1 – protrusion on the support; 2 – mark on the bracket The rubber-metal support can be replaced without removing the front suspension beam bracket from the vehicle....
Removal and installation the anti-roll bar
1. Remove the engine crankcase mudguard. 2. Unscrew the two bolts 3 (see the figure in subsection 7.1.2 ) fastening the rear support 2 of the power unit to the gearbox. 3. Unscrew two bolts 2 on both sides of the...
1. Remove the engine crankcase mudguard. 2. Unscrew the two bolts 3 (see the figure in subsection 7.1.2 ) fastening the rear support 2 of the power unit to the gearbox. 3. Unscrew two bolts 2 on both sides of the...
Checking and adjusting wheel alignment angles
Adjusting the front wheel camber 1 – beam bracket mounting bolt; 2 – front suspension beam bracket; 3 – front suspension beam Adjusting the front wheel alignment 1 – lock nut; 2 – steering rod; 3 – tie rod end Checking...
Adjusting the front wheel camber 1 – beam bracket mounting bolt; 2 – front suspension beam bracket; 3 – front suspension beam Adjusting the front wheel alignment 1 – lock nut; 2 – steering rod; 3 – tie rod end Checking...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Read similar sections on other Skoda models
➧ Chassis (running gear): Front suspension Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Front suspension Skoda Octavia 3 (2013-2019)
➧ Chassis (running gear): Front suspension Skoda Superb 2 (2008-2015)
➧ Chassis (running gear): Front suspension Skoda Kodiaq 1 (2016-2024)
➧ Chassis (running gear): Front suspension Skoda Yeti (2009-2017)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Maintenance
- Petrol engines 1.2 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Petrol engines 1.4 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Petrol engines 1.6 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Diesel engines 1.4 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Diesel engines 1.9 l
- Engine repair
- Cooling and lubrication system
- Power and control system
- Transmission
- Manual gearbox 02R
- Manual gearbox 02T
- Automatic gearbox 09G
- Cardan shaft
- Chassis (running gear)
- Front suspension
- Rear suspension
- Wheels and tires
- Brake system
- Steering system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Electrical circuits
- User manual
- Introduction to manual
- Governing bodies
- Salon equipment
- Driving and maintenance
- Power unit
- Engine repair
- Lubrication system
- Supply system
- Cooling system
- Exhaust system
- Transmission
- Mechanical gearbox 002
- Mechanical gearbox 02T
- Chassis (running gear)
- Front suspension
- Rear suspension
- Steering
- Steering gear without power
- Power steering
- Brake system
- Body and interior
- Body and interior repair
- Interior heating
- Electrical equipment
- Equipment and devices
- Ignition system
- Windshield wipers
- Electrical circuits