Safety regulations Do not touch high voltage wires while the engine is running. Disconnect and connect high-voltage wires only when the ignition is off. Disconnect and connect instrumentation only when the ignition is off. If you need to...
Removal and installation of the ignition module Details of the ignition system of engines 1.0 l, 37 kW and 1.4 l, 50 kW 1 - ignition module; 2 - candles; 3 - connecting block of the ignition module; 4 - bolts; 5 - protective screen; 6 – a bolt of fastening of the...
Checking and replacing spark plugs Engines 1.0 l, 37 kW and 1.4 l, 50 kW On engines of 1.0 l, 37 kW, NGK BKR 6 ETA-10 candles are used, the gap between the electrodes of which is 0.9–1.1 mm. On engines of 1.4 l, 50 kW, candles Champion RC 89 PYC are used...
Checking the power supply circuit of the ignition module Numbering of contacts of the connecting block of the ignition module of engines 1.0 l, 37 kW and 1.4 l, 50 kW Checking the supply voltage of the ignition module Engines 1.0 l, 37 kW and 1.4 l, 50 kW 1. Check battery...
Checking the resistance of the secondary circuit of the ignition module Engines 1.4 l, 55 and 74 kW Checking the resistance of the secondary circuit of the ignition module of engines 1.4 l, 55 and 74 kW 1. Connect an ohmmeter to the high voltage terminals of the first and fourth, and then...
Camshaft Position Sensor 1.0L and 1.4L Engines Camshaft position sensor for 1.0l, 37kW and 1.4l, 50kW engines 1 - connecting block; 2 - sensor The camshaft position sensor sends a signal to the engine control unit about the ignition timing in the first cylinder. If...
Engine Speed Sensor 1.0L and 1.4L Engine Speed Sensor 1.0L, 37kW and 1.4L, 50kW 1 – sensor; 2 - connecting block If the sensor fails while the engine is running, the engine will immediately stop. If restarted, the engine control unit will replace the...
Camshaft position sensor for 1.4L, 55 and 74 kW engines Camshaft position sensor for 1.4L, 55 and 74 kW engines 1 – sensor; 2 - connecting block Examination 1. Check battery voltage first. It must be at least 11.5 V. 2. Remove the upper engine cover (see subsection 2.1 ). 3....