Petrol engine 1.4L (SAHS) Skoda Superb 2

1.4 Petrol Engine Specifications
Type - petrol, 4-cylinder, in-line, DOHC, turbocharged Designation - SAHS The firing order of the cylinders is 1-3-4-2 Cylinder diameter // piston stroke, mm — 76.5 // 75.6 Cylinder capacity, cm³ — 1390 Maximum power,...

Removal and installation of the engine and powertrain supports
Removal Note: The engine is removed from under the engine compartment downwards together with the manual transmission. 1. Relieve the pressure in the fuel supply system and remove the air cleaner ( see Chapter 4 ). 2....

Removal and installation the accessory drive belt and auxiliary bracket
Note: To remove the bracket, remove the drive belt, alternator ( see Chapter 5 ), compressor ( see Chapter 3 ) and unscrew the bracket bolts. 1. Details of the auxiliary drive installation are shown in the accompanying...

Removal and installation the crankshaft pulley and timing belt housing
1. The installation details of the timing belt cover are shown in the accompanying illustration. 17.1 Timing drive installation details 1 Cylinder head, with camshaft housing 2 Cylinder block 3 Auxiliary units bracket 4...

Replacing crankshaft seals
1. The details of installing the crankshaft oil seals are shown in the accompanying illustration. 18.1 Crankshaft oil seal installation details 1 Pulley bolt 2, must be replaced, when tightening the thread must be...

Checking and adjusting the timing phases (setting TDC)
Checking the timing phases 1. Remove the top engine cover. To do this, unscrew the bolts (1 in illustration 15.2), unhook the coolant hoses (2) and pull the cover up. Note: When installing, tighten the bolts to 8 Nm. 2....

Removal and installation of the cylinder head, its cover and other parts
1. Details of installation of the cylinder head and its components are shown in the accompanying illustrations. 20.1a Cylinder head installation and assembly details 1 Bolt, 8 Nm 2 high-pressure fuel pumps, with fuel...

Work on the engine lubrication system
1. The installation details of the lubrication system components are shown in the accompanying illustration. 2. The engine oil pan is installed using sealant D 176 600 A1. 21.1 Lubrication System Component Installation...

Features of engine overhaul
Caution: The presence of metal shavings or large amounts of small metal particles found during engine rebuilds may indicate damage to the crankshaft and connecting rod bearings. To prevent further damage, thoroughly...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Petrol engines Skoda Rapid 1 (2012-2022)
➧ Power unit: Petrol engine 2.0 l Skoda Kodiaq 1 (2016-2024)
➧ Power unit: Petrol engine 1.2 l Skoda Yeti (2009-2017)
➧ Power unit: Petrol engine 1.6 l Skoda Felicia (1994-2001)

Link to this section in various formats

TEXTHTMLBB Code