Front Suspension Specifications Tire inflation pressure - see Specifications to Chapter "Controls and methods of operation" The maximum allowable play of the steering wheel along its outer rim with the engine running, mm - 30 PR number of running gear...
Suspension unloading Note: If components with fixed rubber bushings have been replaced, or the bolts/nuts of these components have been loosened, the suspension must be brought to an unloaded position before tightening the fasteners. 1....
Front suspension subframe work 1. Details of the installation of the subframe are shown in illustrations 1.1a-b. Further steps are described for models with an aluminum subframe. Fixing the position of the subframe and consoles 2. Screw the centering...
Removal and installation of ball joint and suspension arm Ball joint replacement 1. Remove the hub bolt ( see Section 2 of Chapter 8 ). 2. Remove the front wheel. 3. Give nuts ( see illustration 4.5 of chapter 8 ). 4. Slightly pull the drive shaft out of the hub. If equipped,...
Removal and installation of the stabilizer bar 1. Remove the front wheels. 2. Remove the screws (see resist. illustration) and remove the pad behind the pedals. 5.2 Fitting the lining behind the pedals 3. Remove the bolt (1 per resist. illustrations) and disconnect...
Removal and installation of a rotary fist 1. Loosen the bolt securing the drive shaft to the hub assembly ( see Section 2 of Chapter 8 ). 2. Remove the wheel. 3. Remove the anchor bracket together with the brake caliper without disconnecting the brake hose, and...
Removal and installation of a rack of a forward suspension bracket Removal and installation of a rack 1. Details of the assembly of the suspension strut are indicated on resist. illustrations. 7.1 Suspension strut assembly parts 1 shock absorber 2 Rebound damper 3 Protective sleeve 4...
Vehicle wheel alignment — general information Note: Only the toe-in of the front and rear wheels is subject to adjustment. 1. The geometry of the suspension and its rigidity determine the possibility of limiting the vertical movements of the body and reducing the...
Camber and toe adjustment of front wheels Camber adjustment Note: Camber adjustment is not provided, but can be leveled by moving the subframe. 1. Remove the sound insulation under the engine compartment ( see chapter 11 ). 2. Loosen the bolts (1 per resist....