7-speed transmission DSG 0AM car Skoda Superb 2

DSG transmission specifications
DSG transmission fluid type and volume see Specifications to Chapter 1 . Weight of DSG OAM, kg - 72 Weight DSG 02E (FWD // AWD, including corner transmission), kg — 80 // 93 Clutch type OAM - Two single-disk dry, with...

General information about the 7-speed DSG transmission «OAM»
7-speed DSG "OAM" ("DQ200-7F") is installed on petrol models 1.8 l FWD (CDAA/CDAB). The DSG code is indicated on the vehicle data sticker (see Introduction). In addition, identification data is also indicated on the DSG...

Features of carrying out repair works
1. There is a hole in the transmission housing (see accompanying illustration). Make sure that small parts do not fall into this hole when installing the DSG - temporarily close this hole. 2.1 Hole in DSG 2. If the DSG...

Troubleshooting 7-speed DSG transmission «OAM»
If you detect a DSG malfunction, first of all, make sure that there are no leaks of its working fluids ( see Chapter 1 ). The car owner can check/replace the information sensors of the DSG control system. Before...

Removal and installation of DSG
Removal Note: The DSG is removed downwards, separately from the engine. 1. Set the selector lever to position "P". 2. Remove the top engine cover and air cleaner ( see Chapter 4 ). 3. Remove the battery with its holder...

Removal and installation the clutch
Note: The clutch is removed upwards with the DSG removed. When installing a new clutch, it is necessary to determine and adjust the positions of the bearings, after which the clutch is pressed onto the input shaft....

Replacement of working fluid
1. The DSG transmission uses two circuits of working fluids: one for the mechanics part, and the other for the dual clutch control unit. Checking and replacing the DSG working fluids is not required throughout its...

Work with the DSG mode shift drive
1. The gearshift drive components are shown in the accompanying illustrations. On models up to 06.2009, the selector cable can be replaced separately, and from 06.2009, the cable is fixed to the selector assembly and...

Removal and installation the «Mechatronic» unit
Attention: Block "Mechatronic" is under high pressure and must not be disassembled. 1. Block location "Mechatronic" shown in Illustration 1.5 (item 5). The description of removal/installation is given for the case when...

Features of replacing flange shaft seals
1. Do not remove both drive shafts from the transmission at the same time, otherwise it will not be possible to hold the opposite wheel fixed to loosen/tighten the flange shaft bolts. 2. Do not loosen both the left and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code