Car rear suspension Skoda Superb 2
Removal and installation the subframe
FWD models 1. Remove the rear wheels and the rear part of the exhaust system ( see Chapter 4 ). 2. Remove the rear suspension springs ( see Section 12 ). 3. If there is a suspension height sensor, disconnect its wiring...
FWD models 1. Remove the rear wheels and the rear part of the exhaust system ( see Chapter 4 ). 2. Remove the rear suspension springs ( see Section 12 ). 3. If there is a suspension height sensor, disconnect its wiring...
Removal and installation the guide and transverse suspension arms
Upper wishbone (fWD models) 1. Remove the rear wheel. 2. Remove the rear suspension spring ( see Section 12 ). 3. Unhook the wire from the upper control arm ( arrow A in illustration 3.29a of Chapter 8 ) ABS wheel...
Upper wishbone (fWD models) 1. Remove the rear wheel. 2. Remove the rear suspension spring ( see Section 12 ). 3. Unhook the wire from the upper control arm ( arrow A in illustration 3.29a of Chapter 8 ) ABS wheel...
Removal and installation the trailing arm and hub assembly holder
Note: The removal and installation of the hub assembly holder is described in Section 3 Chapter 8 . 1. Remove the rear wheel and rear suspension spring ( see Section 12 ). 2. Remove the parking brake cable holder...
Note: The removal and installation of the hub assembly holder is described in Section 3 Chapter 8 . 1. Remove the rear wheel and rear suspension spring ( see Section 12 ). 2. Remove the parking brake cable holder...
Removal and installation the shock absorber and spring
Note: The installation details of the spring and shock absorber are shown in Illustration 1.3. Spring 1. Remove the wheel. 2. Install the spring compressor (see accompanying illustration), make sure that the spring fits...
Note: The installation details of the spring and shock absorber are shown in Illustration 1.3. Spring 1. Remove the wheel. 2. Install the spring compressor (see accompanying illustration), make sure that the spring fits...
Removal and installation the anti-roll bar
1. The details of the stabilizer installation are shown in the accompanying illustration. 13.1 Installation details of the stabilizer for AWD models (FWD models are similar) 1 Stabilizer 2 Support, replaceable on both...
1. The details of the stabilizer installation are shown in the accompanying illustration. 13.1 Installation details of the stabilizer for AWD models (FWD models are similar) 1 Stabilizer 2 Support, replaceable on both...
Removal and installation the rear suspension height sensor
1. The installation details of the left G76 rear suspension height sensor are shown in the accompanying illustration. 14.1 G76 Sensor Installation Details 1 Subframe 2 Lower wishbone 3 Bolt, 5 Nm 4 Sensor G76 Arrow -...
1. The installation details of the left G76 rear suspension height sensor are shown in the accompanying illustration. 14.1 G76 Sensor Installation Details 1 Subframe 2 Lower wishbone 3 Bolt, 5 Nm 4 Sensor G76 Arrow -...
Checking the camber and toe-in of the rear wheels
Camber adjustment 1. Loosen the nut (And on the accompanying illustration) upper wishbone mounts on the subframe and adjust the camber by turning the hex head of the eccentric bolt (B), then tighten the nut to 95 Nm....
Camber adjustment 1. Loosen the nut (And on the accompanying illustration) upper wishbone mounts on the subframe and adjust the camber by turning the hex head of the eccentric bolt (B), then tighten the nut to 95 Nm....
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Read similar sections on other Skoda models
➧ Chassis (running gear): Rear suspension Skoda Fabia 2 (2007-2014)
➧ Chassis (running gear): Rear suspension Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Rear suspension Skoda Octavia 3 (2013-2019)
➧ Chassis (running gear): Rear suspension Skoda Kodiaq 1 (2016-2024)
➧ Chassis (running gear): Rear suspension Skoda Yeti (2009-2017)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Car driving
- Maintenance
- Power unit
- Petrol engines 3.6 l
- Petrol engines 1.4 l
- Petrol engines 1.8/2.0 l
- Diesel engines 2.0 l
- Diesel engines 1.9 l
- Cooling system
- Climate system
- Power and exhaust system
- Ignition and preheat system
- Launch and charge system
- Transmission
- Manual gearbox and clutch
- 7-speed DSG gearbox
- 6-speed DSG gearbox
- Transmission line
- Chassis (running gear)
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Lighting and signaling
