2. The engine oil pan is installed using sealant D 176 600 A1.
21.1 Lubrication System Component Installation Details
1 Dipstick for measuring engine oil level
2 Oil cooler
3 O-ring, subject to replacement
4 Coolant pipe, for oil cooler, fastened with a force of 20 Nm
5 Bolt, 8 Nm
6 Cork
7 Sealing ring
8 Oil filter, with gaskets and non-return valve, 20 Nm
9 Timing chain cover
10 Bolt, 10 Nm
11 Bolt, to be replaced, 150 Nm, then tighten to an angle of 90°, when tightening the thread must be lubricated, but the bearing surface must not
12 Crankshaft pulley, bearing surfaces must not be lubricated
13 Front crankshaft oil seal
14 Bushing, bearing surfaces must not be lubricated
15 Gasket
16 Crankshaft sprocket
17 Bolt, to be replaced, 20 Nm, then tighten to an angle of 90°
18 Oil pump sprocket
19 Oil pump drive chain
20 Bolt, 10 Nm
21 Sensor "G266" of engine oil level and temperature
22 Drain plug, with integrated seal, replaceable, 30 Nm
23 Bolt, subject to replacement, 13 Nm
24 Bolt, 40 Nm
25 Oil pan
26 Bolt, 25 Nm
27 Oil pump
28 Bolt, 5 Nm
29 Oil separator