Climate system of the car Skoda Superb 2

General information about the climate system
Description of the climate system The description of the climate control system is given in Chapter " Controls and operating techniques " The main components of the climate control system located in the vehicle interior...

Removal and installation of the air conditioning fan and its resistor/control unit assembly
Note: The "V2" fan is accessible from the front right footwell. 1. Remove the two plastic bolts ( 2 in illustration 15.1 Chapter 1 ) and remove the shield (1) of the climate control system housing. 2. To remove the...

Removal and installation of air ducts, deflectors and grilles
1. To remove the side deflector (1 on the accompanying illustration) open it and insert the tool (2) to remove the lock so as not to damage the ribs and hook this tool onto the edge of the deflector (arrow A), then pull...

Removal and installation the panel and control unit of the climate control system
1. Turn off the ignition and all electrical equipment. 2. Carefully pry up with plastic wedge #3409 and remove the pads (1 and 2 in the accompanying illustration) central console, unscrew the screws (3), pull out the...

Removal and installation damper actuators
Activator "V113" of the circulation flap (system "Climatic") 1. Remove the main storage compartment ( see Chapter 11 ). 2. Remove the cover (1 on the accompanying illustration) activator "V113" (2), disconnect its...

Removal and installation of the heater radiator and auxiliary heating element Z35
Heater radiator 1. Set the climate control system to maximum temperature, turn off the ignition and all electrical appliances. 2. Clamp the coolant hoses (1 on the accompanying illustration) heater radiator, mark them,...

Removal and installation climate control system sensors
Note: G191/G192 sensors are not installed on models from week 46 of 2010. 1. To remove the "G263" evaporator outlet temperature sensor, remove the right side trim of the center console, disconnect the connector (1 on...

Removal and installation, disassembly and assembly of the climate control system housing
Note: All electrical wiring ties must be installed in their original places. The electrical wiring harness is removed together with the climate control system housing. 1. On some engines, it may be necessary to remove...

Work with additional heater
Note: The nameplate with the additional heater data is located on the heater itself and is also duplicated on the front panel of the engine compartment. 1. The location of the main parts of the additional heater are...

Removal and installation of the refrigeration unit compressor
Note: For instructions on removing/installing the auxiliary bracket for mounting the compressor, see Chapter 2 . 1. Drain the refrigerant from the refrigeration unit. 2. Remove the accessory drive belt ( see Chapter 2...

Removal and installation of other components of the refrigeration unit
Note: The location of the refrigeration unit components is shown in Figure 8.2. A description of replacing the evaporator temperature sensor "G263" is given in Section 14 . Note: On models with a Denso condenser, the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link to this section in various formats

TEXTHTMLBB Code