Brake system of the car Skoda Superb 2

Brake system specifications
General information Brake system type - Double diagonally split circuit Type and volume of brake fluid - see Specifications to Chapter 1 Maximum permissible pressure drop from 50 bar in 45 seconds¹, bar - 4 ABS/ESP...

General information and safety precautions
General information Depending on the vehicle modification, different brake mechanisms may be installed ( see Specifications ). The brake system is divided diagonally into two independent hydraulic circuits and consists...

Repair and maintenance of front brake mechanisms
Note: Brake pads should be replaced in pairs and on both wheels of the same axle at the same time. Note: If the pads are not being removed for replacement, i.e. will be reinstalled, mark them before removal so that they...

Repair and maintenance of rear brake mechanisms
1. The details of the rear brake mechanisms are shown in the accompanying illustrations. 3.1a Rear brake mechanism parts CII-41 (fWD and AWD models) 1 ABS sensor (fVVD models), before installation, clean the walls of...

Repair and maintenance of the parking brake
1. The parking brake parts are shown in the accompanying illustration. 4.1 Parking brake parts 1 Parking brake lever, remove center console before removing (see Chapter 11) 2 Nut, 20 Nm 3 Tension pin 4 Equalizer 5...

Removal and installation the brake pedal, D/W brake lights and brake pedal position sensor
1. The brake pedal mounting parts are shown in the accompanying illustration. Before installation, lubricate all mounting points with polyurea grease G052 142A2. 5.1 Brake pedal mounting parts 1 Brake pedal bracket 2...

Removal and installation of the brake master cylinder, vacuum booster and brake fluid reservoir
1. The details of the brake master cylinder, brake booster and brake fluid reservoir are shown in the accompanying illustration. 6.1 Details of the brake booster unit, brake booster and brake fluid reservoir 1 Brake...

Removal and installation the vacuum pump and sensor G608, checking the non-return valve
1. Description of removal and installation of the vacuum pump is given in Sections 30 and 39 Chapters 2. 2. Through a non-return valve (And on the accompanying illustration) air should flow only in the direction of the...

Removal and installation of the hydraulic modulator and ESP control unit
1. The installation details of the hydraulic and electronic control units are shown in the accompanying illustration using the "Mark 60EC" unit as an example. The assembly is located on the right side of the engine...

Removal and installation sensors
1. The description of the removal and installation of the assembly of the D/V "F" brake lights and the "F47" clutch pedal position sensor is given in Section 5. 2. The "G419" ESP sensor assembly, which includes the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Chassis (running gear): Brake system Skoda Fabia 1 (1999-2007)
➧ Chassis (running gear): Brake system Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Brake system Skoda Octavia 1 (1996-2004)
➧ Chassis (running gear): Brake system Skoda Kodiaq 1 (2016-2024)
➧ Chassis (running gear): Brake system Skoda Yeti (2009-2017)
➧ Chassis (running gear): Brake system Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code