Contents: Front seat ⬇ Rear seats ⬇
Front seat
1. To remove the front seat (1 in the illustration) disconnect the negative battery cable, move the seat forward, remove the bolts (2), then move the seat back, remove the bolts (3) and disconnect the electrical wiring connectors under the seat.
19.1. Front seat mounting bolts
2. Front seat parts are shown in the illustration. To remove the right trim, remove the seat and seat belt buckle (see Section 20), and then remove the retainer (2). To remove the left pad, remove the seat, remove the handle (9) and flywheel (7), and then remove the retainer (8).
19.2. Driver's seat parts 1. Right overlay; 2, 8. Spacer clamps; 3 Seat back; 4. Lumbar support adjustment lever; 5. Seat height adjustment lever; 6, 11. Bolt, 3.5 Nm; 7. Backrest tilt adjustment flywheel; 9. Seat height adjustment handle; 10. Left overlay; 12. Retainer; 13. Glove box; 14. Screw; 15. Forward/backward seat adjustment handle; 16. Seat cushion
3. To remove the glove box (5 in the illustration) under the seat remove the left seat cover (see paragraph 2), unscrew the screw (2), release the fasteners (3) on both sides with a screwdriver and pull out the drawer completely. Then unscrew the screws (4), pry up the retainer (12 in illustration 19.2), tilt the glove box and squeeze it out of the latches (arrows in the illustration) in the seat.
19.3. Removing the glove compartment
4. To separate the seat back from the seat cushion, remove the seat and the seat belt buckle (see Section 20). Remove the flywheel from the seat (7 in the illustration) and the height adjustment handle (9), remove the spacer clips (2 and 8) and remove the left and right pads (1 and 10). Disconnect the electrical wiring connectors under the seat, cut the electrical wiring ties. Remove the bolts (1 in the illustration) and remove the back. When installing, tighten the backrest mounting bolts to 33 Nm.
19.4. Backrest mounting bolts
(Information presented on the website: «www.SkodaBook.ru»)
Rear seats
5. Pull the handle (2 in the illustration) in the direction of the arrow (A) and fold the backrest (1) in the direction of the arrow (B).
19.5. Folding the seat back
6. Pull the lever (2 in the illustration) in the direction of the arrow (A) and fold the seat (1) in the direction of the arrow (B).
19.6. Folding the seat
7. Pull the lever (2 in the illustration) in the direction of the arrow, lift the seat (1) to the vertical position and remove it upwards.
19.7. Removing the seat
8. If necessary, after removing the rear seats, you can remove their mounting strip (1 in the illustration), by unscrewing the bolts (2). When installing, tighten the bar bolts with a force of 23 Nm.
19.8. Rear seat mounting strip