Contents: Removal ⬇ Installation ⬇
Note: New nuts for the mounting bolts will be required during assembly.
Removal
1. Support the front wheels with chocks, then jack up the rear of the car and place it on supports.
2. Loosen the nuts on the bolts securing the stabilizer bar anchor plates to the bottom of the axle. Remove both plates and pull the stabilizer bar out from under the car.
Installation
1. Place the stabilizer bar in its regular place and secure it with anchor brackets. Don't forget to put washers under the nuts of the mounting bolts.
2. Tighten both nuts to the required torque, then lower the vehicle to the ground.
Information taken from this resource (Skodabook.ru)