13.1 Installation details of the stabilizer for AWD models (FWD models are similar)
1 Stabilizer
2 Support, replaceable on both sides at the same time
3 Clamp
4 Bolt, subject to replacement, tightened only with unloaded suspension; 20 Nm, then tighten to an angle of 90°
5 Hub assembly holder
6 Self-locking nut, subject to replacement: on AWD models - 40 Nm, on FWD models - 45 Nm
7 Bolt
8 Stabilizer link
9 Subframe
2. Remove the rear wheels.
3. Give the nut (1 in illustration 10.34) and separate the anti-roll bar from its stand (2).
Text taken from this website SKODABOOK.RU
4. Check the stabilizer clamp bolts (see illustration 10.35).
5. Installation is performed in the reverse order. Tighten the clamp bolts evenly with the suspension unloaded.