Removal and installation of interior lighting fixtures and their lamps (Skoda Yeti 5L)

Note: When replacing bulbs, follow the instructions given before the subsection "Replacing headlight bulbs" Section 5.

1. To remove the front interior light (1 in illustration 7.1a) pry up with a plastic wedge and remove the cover (2) or remove the glasses case, unscrew the screws (arrows), release the lamp from the frame (3), pull it down and disconnect the connector. After removing the lamp, you can remove the interior lighting lamp from its contacts, remove the sockets (see illustration 7.1b) and remove the reading lamps from them.





2. To remove the rear interior light, use a screwdriver to pry up its retainer (see illustration 7.2a), remove the light from the ceiling trim and disconnect the connector. To replace the bulb, remove the cover from the rear interior light (see illustration 7.2b).







3. To remove the glove box or luggage compartment light, use a screwdriver to pry up its retainer (see illustration), remove the light from the panel and disconnect the connector. If necessary, replace its bulb after removing the light.





4. To remove the signal light in the door, use a screwdriver to pry up its retainer and remove the light from the door trim (see illustration 7.4a) and disconnect the connector. If necessary, remove the cover from the flashlight after removing it (see illustration 7.4b) and replace its W3W bulb.