Switch housing fastening (castle) ignition
1 - switch case (castle) ignition; 2 – a bolt of fastening of the case; 3 - steering column
1. Remove the steering column switch (see subsection 10.11).
2. Disconnect block 1 (see fig. Circuit breaker connectors (castle) ignition) with switch wires (castle) ignition.
3. Disconnect block 4 with immobilizer wires.
4. Disconnect from steering column «mass» wire 3.
5. Remove the switch (lock) ignition.
6. Remove two bolts 2 (see fig. Switch housing fastening (castle) ignition) switch housing fasteners (castle) ignition heads with broken heads. This can be done, for example, with a hammer and chisel.
7. Remove switch housing 1 (castle) ignition.
8. Install the new switch housing (castle) ignition and secure it with new breakaway head bolts. Tighten the bolts until the heads pop off.
9. Then reassemble in reverse order.