Removal and installation of a steering column Removing Note. The steering column is supplied as a single piece, repair is not provided. Before starting any work related to the removal of the steering column, it is necessary to disconnect the negative terminal from...
Electronic power steering control module — removal and installation Removing 1. Remove the steering column assembly (for details, see the relevant section in this chapter). 2. Lay the steering column on its side on a clean surface. 3. Disconnect the connectors of the two wiring...
Steering wheel lock — removal and installation Attention. Be extremely careful when connecting the battery after assembly. Removing 1. Disconnect the negative terminal from the battery and wait at least three minutes before starting any work. 2. Remove the front...
Steering gear assembly — appearance 1. Right tie rod end 2. Lock nut, locking torque 50 Nm 3. Small collar of fastening of an anther of steering draft 4. Tie rod boot 5. Large tie rod boot clamp 6. Gasket 7. Right tie rod 8. Steering gear assembly 9. Left...
Removal and installation of the steering mechanism Removing 1. Disconnect the negative terminal from the battery. 2. Remove the screw (arrow), connecting the universal joint of the steering column and the steering gear shaft (1), as shown in the figure below. Pull and...