Car clutch repair Skoda Rapid 1

General view of the clutch
1. Body cross member 2. Bushing 3. Pedal mechanism mounting bracket 4. Fastening nut, tightening torque 25 Nm 5. Clutch pedal switch "F36" 6. Safety support 7. Fastening screw, tightening torque 9 Nm 8. Limiter 9....

Removal and installation the clutch pedal switch
Note: To ensure a sufficiently strong installation in the pedal support bracket, the "F36" clutch pedal switch can be installed only once. Removal 1. Remove the air duct nozzle into the footwell (see the relevant...

Clutch master cylinder with bracket — removal and installation
Note: After disconnecting and then reconnecting the wire connecting the battery terminal to the vehicle ground (body), some additional work must be performed. 1. Remove, if necessary, the upper decorative engine cover....

Clutch pedal with booster spring — removal and installation
Removal Note. Install the clutch pedal with a new bearing journal. If only the return spring is to be removed, there is no need to disconnect the clutch pedal from the clutch master cylinder. 1. Remove the air duct...

Clutch release hydraulic drive
General view (Rapid) 1. Expansion tank of the master brake cylinder 2. Spring clamp 3. Supply hose 4. Clutch release hydraulic master cylinder 5. Support 6. Clutch release pedal 7. Fastening clamp 8. Fastening nut,...

Control of the hydraulic clutch control drive
Attention. The return of the pedal must not be obstructed by shifted or additional floor coverings (rugs). If necessary, remove air from the clutch control drive. 1. First, you should check the brake fluid level in the...

Clutch master cylinder — removal and installation
Removal 1. Remove the bracket with the clutch release hydraulic master cylinder. 2. Unlock the clutch pedal from the master cylinder of the clutch control booster using the T10005 pliers, as shown in the figure below....

Removal and installation the clutch release slave cylinder
Removal Note. Necessary special devices, control and measuring instruments, as well as auxiliary means. Grease for clutch disc splines (G 000 100). Note: After disconnecting and then reconnecting the wire connecting the...

Removal air from the clutch control drive (bleeding the hydraulic drive)
Note. Necessary special devices, control and measuring instruments, as well as auxiliary means: Device for filling and bleeding, e.g. (VAS 5234). Note. When performing the following work, make sure that no brake fluid...

Clutch release fork and release bearing
General appearance 1. Gearbox 2. Ball joint, 25 Nm 3. Oil seal for drive shaft 4. Guide sleeve 5. Retaining spring 6. 20 Nm 7. Clutch release lever 8. Clutch release bearing 9. Slave cylinder of the shut-off drive 10....

Centering the clutch disc, removing and installing the pressure plate
1. Tighten and loosen the screws in a crosswise pattern. 2. When removing and installing, use the locking tool (MP1-223 (3067)). Note. Before installing the screws, it is necessary that the running surface of the clutch...

Possible malfunctions and ways to eliminate them

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Transmission: Clutch Skoda Octavia 1 (1996-2004)
➧ Transmission: Clutch Skoda Kodiaq 1 (2016-2024)
➧ Transmission: Clutch Skoda Yeti (2009-2017)
➧ Transmission: Clutch Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Rapid 1 (2012-2022)