Vehicle drive shafts Skoda Rapid 1

Removal and installation drive shafts
Removal 1. Remove the screw for securing the drive shaft to the wheel hub. Note. In this case, the car must not rest on its wheels, otherwise the wheel hub bearing may be damaged. If the screw is loosened, the bearing...

Constant velocity ball joint — external appearance
1. Right drive shaft (tubular) 2. Fastening bolt 3. Pressure plate 4. Small clamp for fastening the boot 5. Dust cover for inner constant velocity joint 6. Disc washer 7. Internal constant velocity ball joint 8. Sealing...

Disassembling drive shafts
Note. Necessary special devices, control and measuring instruments, as well as auxiliary means: Support board "MP3-406 (VW 401)". Support board "MRZ-407 (VW402)". Pressure piece "MRZ-411 (VW 454)". Press punch - stamp...

Assembly of drive shafts
Position for assembling the disc spring on the inner hinge 1. Disc spring Position for assembly of disc spring and thrust ring on outer hinge Press the joint until it stops. Put on the retaining ring. 1. Disc spring 2....

External joint control
Note: The joint must be disassembled when replacing the filled grease, in case of significant contamination or when checking the running tracks of the support balls for wear and damage. 1. Before starting disassembly,...

Inner joint control
Note: The joint must be disassembled when replacing the filled grease, and in the case of significant contamination or when checking the bearing ball races for wear and damage. 1. Tilt the hub and ball race. 2. Press...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Transmission: Drive shafts Skoda Kodiaq 1 (2016-2024)
➧ Transmission: Drive shafts Skoda Yeti (2009-2017)
➧ Transmission: Drive shafts Skoda Felicia (1994-2001)

Link to this section in various formats

TEXTHTMLBB Code

Rapid 1 (2012-2022)