Removing
1. Turn off the ignition and all electrical consumers.
2. Using a special tool (Т10389) or through a hole in the wheel arch trim panel in the luggage compartment (1), unfasten the fasteners (2), as shown in the figure below.
3. Unscrew the fastening screws (3), shown in the figure below. The tightening torque of the fastening screws during installation is 2.5 Nm.
4. Pulling in the direction of the arrow, disconnect from the supporting surface and remove the rear light combination housing (1), as shown in the figure below.
5. Unlock and disconnect the wiring harness connector (2), as shown in the figure below.
Installation
Installation is carried out in the reverse order of removal.
Note. Be extremely careful to ensure correct installation and not damage the seals.
Attention. Before installing the lamp housing, make sure that the wiring harness is completely routed through the hole into the vehicle panel housing.