Removing
1. Remove cover (1) from the latch, as shown in the figure below, and pull it down.
2. Gently push out the atomizer (2) rear window washer (arrow), as shown in the picture below (except Spaceback models).
3. Loosen the fastening nut by turning it one turn.
4. Install the fixing nut on the M6 fixing nut (4) (does not apply to the Spaceback model), as shown in the figure below.
5. Using a special puller (3), disconnect the wiper arm (1) rear window as shown in the figure below.
Note. Whenever removing the lever, it is necessary to use the thrust part (2), so as not to damage the threaded part.
6. Fully unscrew the fastening nut and remove the rear window wiper arm.
Installation
1. With the ignition on, rotate the rear window wiper motor to reset it.
2. Install the rear window wiper arm and secure it with the nut, hand-tight.
3. Set the final home position of the rear window wiper arm. For this:
Adjust the wiper arm so that the distance «A» matched the required value «A» = 42±2 mm.
Rapid Spaceback
- Version I - «A» = 183±2 mm
- Version II - «A» = 52±2 mm
4. Tighten the fastening nut with a tightening torque of 12 Nm.
5. Check and make sure that the rear window cleaner is working properly.