Removal and installation the rear window wiper motor and lever (Skoda Superb B6)

1. Open the lid and remove the nut (arrow on the accompanying illustration) and remove the lever by slightly rocking it. If you cannot remove the lever, remove the injector (see Section 12) and use a puller.



2. After removing the lever, remove the lower trim panel of the tailgate, disconnect the connector (1 on the accompanying illustration), disconnect the hose (2) from the electric motor and unscrew the bolts (arrows) and remove the electric motor.



3. Installation is carried out in the reverse order. Make sure that the seal is correctly positioned in the hole in the rear window. After installation, adjust the parking position of the lever (see Section 7 Chapter 1). Tighten the lever mounting nut with a force of 12 Nm, and the electric motor mounting bolts with a force of 7 Nm.

Information taken from this resource SKODABOOK