Removal and installation the coolant circulation pump (Skoda Yeti 5L)

Petrol models 1.2 l

1. Remove the sound insulation under the engine compartment (see Chapter 11).

2. Disconnect the connector (1 in the illustration), unscrew the bolt (3) and remove the coolant circulation pump "V50" from the bracket. Clamp the coolant hoses (2) and disconnect them from the pump, collecting the leaking coolant.



3. Installation is carried out in reverse order. Tighten the pump mounting bolt to 8 Nm.

Petrol models 1.4 l

4. The installation details of the coolant pump and coolant circulation pump are shown in Figure 4.10.

Text obtained from the website [SkodaBook.ru]

5. Removal of the "V50" pump is carried out in the same way as removal of the "V50" pump of a 1.2 l petrol engine (see subsection above).

Petrol models 1.8 l

6. The installation details of the coolant circulation pump are shown in the illustration.





7. Open the expansion tank and remove the sound insulation under the engine compartment (see Chapter 11).

8. Disconnect the connector (1 in illustration 23.26 Chapter 2) coolant circulation pump "V51", disconnect the hoses (arrows), unscrew the bolt (2) and remove the pump.

9. Installation is carried out in reverse order.

Diesel models 2.0 l (engines CFHC, CFJA, CLCB).

10. Installation details of the coolant circulation pump No. 2 "V178" are shown on illustrations 7.7.