Removing the seat height adjustment lever
1 - lever; 2 - bolts; 3 - plugs
Dismantling the front seat
1 - handle for adjusting the backrest; 2 - screw; 3 - left side lining; 4 - glove box; 5 - right side lining; 6 - spring
Attaching wires to the seat
1 - clamps; 2 - clamp; 3 - wire
Attachment for seat height adjustment
1 - device; 2 - bolts
Seat back fixing
1 - bolts; 2 - back; 3 - pillow
1. Remove the seat from the car.
2. Rock lever 1 (see fig. Removing the seat height adjustment lever), having previously set it to the upper position, so that the seat is in the upper position.
3. Take out plugs 3 and turn away bolts 2 fastenings of the lever of adjustment of a seat on height.
4. Remove lever 1 for seat height adjustment.
5. Remove handle 1 (see fig. Dismantling the front seat) adjust the seatback by pulling it towards you.
6. Turn away four screws 2 fastenings and remove a ware box 4 under a seat.
7. Loosen the fastening screws 2 and remove the side trims 3 and 5 from the seat.
8. For models equipped with side airbags and heating, depending on the configuration, remove the blocks with wires from the holder 6 (see fig. Front seat connectors) and disconnect the block with the wires of the heating regulator 5. Cut the plastic clamps 4 of the wire fasteners. Cut the clamps 1 (see fig. Attaching wires to the seat) from the side of the seat.
9. Disconnect two springs 6 (see fig. Dismantling the front seat) from the seat frame.
10. Loosen three screws 2 (see fig. Attachment for seat height adjustment) fasteners and remove the device 1 seat height adjustment.
11. Loosen two bolts 1 (see fig. Seat back fixing) fasteners on both sides of the seat and remove the backrest 2 from the seat.
12. Assemble the seat in the reverse order, pressing the clamp 1 (see fig. Attaching wires to the seat) clamp 2 as shown in the figure.