Rear seat backrest fastening
1 – retainer; 2 – finger; 3 – side support; 4 – middle support; 5 – back; 6 – protective cap; 7 – backrest bracket
1. Remove both headrests from the seat backs.
2. Lift the front edge of the cushion 1 (see figure Folding down the rear seat cushion) back seat. Then, pulling it by the rear edge, install pillow 2 (see the figure in clause 3 of subsection 1.9) vertically behind the backs of the front seats.
3. Disengage the wire clips 1 by pressing them in the directions indicated by the arrows.
4. Remove the pillow from the car.
5. Release the backrests 2 (see the figure in clause 4 of subsection 1.9) seats, pull out the button 1 of the lock, and fold them into a horizontal position.
6. Using a screwdriver, press down the lock 1 (see the figure Rear seat backrest fastening), pull the seat pin 2 upwards from the side support 3.
7. Remove the protective cap 6.
8. Remove the backrest bracket 7 from the axis of the middle support 4.
9. Remove the backrest from the passenger compartment.
10. Remove the second backrest in the same way.
11. Install the rear seat in reverse order.