Vehicles with automatic transmission
Unclip gearshift cover -2-. Remove switches -1- from below -arrow- from trim -2-.
Vehicles with manual gearbox
Carefully! When using a lever tool, seal the places where the lever tool is inserted with ordinary adhesive tape.
Push release tool -T30098- at rear center into gap between trim frame and selector lever boot -arrow 1-. Using the release tool, carefully release the selector lever cover from the center console -arrow 2-. Turn boot inside out over shift knob.
Remove switches -1- from below -arrow- from gearshift cover.
All vehicles
Disconnect connectors. Use a small screwdriver to pry out the locking tabs -arrows A-. Separate switch strips -1- and -2- from each other -arrows B-.
Installation
Installation in reverse order. Insert the connected switch strips into the mounting hole so that the latches audibly click into place.