Supply system 1.4 liter engine Skoda Octavia 3

Installation locations of injection system components in the engine compartment
1. Valve 1 of the valve timing regulator "N₂05" 2. Valve 1 of the exhaust valve timing regulator "N318" 3. Lambda probe after neutralizer "G130" 4. Lambda probe "G39" 5. Boost pressure regulator "V465" 6. Accelerator...

Overview of the installation locations of the injection system components on the right side of the engine
1. Oil level and temperature sensor "G266" 2. Coolant temperature sensor "G62" 3. Oil pressure sensor "F22" 4. Oil pressure regulating valve -N428-

Removal and installation the intake air pressure sensor «G42» with the intake manifold pressure sensor «G71»
Remove the air filter housing. Disconnect connector "1". Unlock the "arrow" clamps and remove the boost pressure sensor "G31" with the intake air temperature sensor "G42". Installation Installation in reverse order....

Removal and installation the fuel pressure sensor «G247»
Disconnect connector "1". Unscrew the fuel pressure sensor "G247" "2" using the 27 mm end cap "T40218". Installation Installation in reverse order. Note: Do not wet the threads of the fuel pressure sensor.

Middle and rear parts of the exhaust system — general installation diagram
1. Middle and rear parts of the exhaust system: in the original version a single unit, during repairs they are replaced separately 2. 20 Nm 3. Bracket: take into account the part number 4. Suspension: replace if...

Replacement of the middle or rear part of the exhaust system
A/m with the middle and rear parts of the exhaust system combined into one unit Cut the exhaust pipe at the dividing point "arrow 1" at a right angle using a body saw, e.g. VAG 1523/A-. Cars with split middle and rear...

Ignition system — general installation diagram
1. 20 Nm; the tightening torque affects the operation of the knock sensor 2. Knock sensor 1 -G61 - 3. Spark plug, 22 Nm: removal and installation with a spark plug wrench, for example, - 3122 B-; take into account the...

Removal and installation of ignition coils with output stages
Ignition coils for "cylinders 2, 3 and 4" Loosen clamps -1, 2- and remove the air duct. All Disconnect connector "2". Unscrew screw "1". Press the puller "T10530" into the opening of the ignition coil "1" until it...

Removal and installation Hall sensor 3 «G300»
Loosen clamps -1, 2- and remove the air duct. Disconnect connector "1". Unscrew screw "2" and remove Hall sensor 3 "G300". Installation in reverse order.

Removal and installation the engine speed sensor «G28»
Remove the noise-insulating casing. Unscrew the screw "arrow" and push aside the coolant pump after switching off the engine "V51". Disconnect connector "1". Unscrew screw "2" and remove engine speed sensor "G28"....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Diesel engines 1.9 l: Power and control system Skoda Fabia 2 (2007-2014)
➧ Power unit: Power and control system Skoda Rapid 1 (2012-2022)
➧ Power unit: Power and exhaust system Skoda Superb 2 (2008-2015)
➧ Power unit: Power and control system Skoda Yeti (2009-2017)
➧ Power unit: Fuel and exhaust system Skoda Favorit (1987-1994)

Link to this section in various formats

TEXTHTMLBB Code

Octavia 3 (2013-2019)