Interior rear view mirror Removal and installation of an internal rear-view mirror Turn interior rear view mirror -2- by 90°in direction of -arrow- and remove from retaining plate -1-. Installation in reverse order. Removal and installation of...
Removal and installation of the center console Removal and installation of the center console with armrest 1. Left facing 2. Center console 3. Noise isolation 4. Handbrake lever pad 5. Screw - 1.5 Nm 6. Screw - 1.5 Nm 7. Screw - 1.5 Nm 8. Right facing 9. Cap: Under...
Removal and installation of a sun-protective peak 1. Right sun visor bracket 2. Removing the sun visor bracket plug 3. Sun visor 4. Clamps left sun visor bracket 5. Plugs for the left bracket of the sun visor Removing the right holder Detach sun visor (pos. 3) from the...
Removing and installing a handrail on the ceiling Lower handrail -1- and remove both spacer clips -2- in direction of -arrow-. Unlock clips -arrows- with tool -T10517- and detach. Installation Insert the handrail -1- into the holes until it clicks audibly. Insert...
Details and knots of seat belts Parts and assemblies of the front three-point seat belt 1. Screw: Replace the screw after an accident with the seat belt fastened; 40 Nm 2. Safety belt hook 3. Screws: 4.5 Nm 4. Front belt guide: Observe installation...
Removal and installation of a forward three-point seat belt Attention! When working on seat belts, observe the general safety rules for handling the pyrotechnic modules of the airbags, seat belt pretensioners and the battery disconnector. Observe special instructions for...
Removal and installation of an average back three-point seat belt Remove the seat. Remove the middle rear seat belt buckle. Remove seat back. Remove the upholstery from the back. Loosen nut -1-. Unhook and remove the inertial coil -2-. Unhook belt strap -3-. Installation When removing...
Removal and installation of the front belt guide Remove lower section of B-pillar trim. Release two screws -2- and remove guide -1-. Installation Installation in reverse order. Note: Observe the installation position of the seat belt guide when installing.
Removal and installation of locks of seat belts Removal and installation of the lock of a forward seat belt Remove the front seat. Disconnect the seat belt buckle connector under the seat frame. Disconnect wire from seat frame. Remove screw -3-, remove lock -1- from...
Airbags — General Safety Rules General safety rules for working on pyrotechnic modules for airbags, seat belt pretensioners and battery disconnection device Attention! Pyrotechnic assemblies contain substances that produce gas when burned. Some...
Location of inflatable airbags 1. Front passenger side airbag: With squib. 2. Front passenger head airbag: With squib. 3. Rear side airbag, passenger side: With squib. 4. Side airbag driver: With a squib. 5. Driver's upper airbag: With squib. 6....
Details and components of the steering wheel 1. Steering wheel. Removal: Airbag assembly on the driver's side. Set the steering wheel to the middle position (wheels in straight ahead position). Remove screw -2-. Mark position of steering wheel and shaft -4- with a...
Parts and assemblies of the driver's airbag 1. Steering column control unit: With airbag spiral cable with slip ring. 2. Normal (not multifunctional) steering wheel: Equipment variant. 3. 30 Nm + 90°: Can be reinstalled up to five times, then replaced. After each...
Replacing the cable in the airbag Attention! When working on airbags, observe the general safety regulations for handling the pyrotechnic modules for airbags, seat belt pretensioners and the battery disconnector. Remove the airbag assembly on the...
Parts and assemblies of the front passenger airbag 1. Connector: Front passenger airbag igniter 1 2. Screws: 7 Nm 3. Front panel: Replace the front panel after the airbag has deployed 4. Connector 5. Screws: 7 Nm 6. Front passenger airbag: With front passenger airbag...
Parts and assemblies of the front side airbag 1. Back frame 2. Hook: For attaching the side airbag to the backrest frame. 3. Front side airbag: On the driver's side - with a squib. From the front passenger side - with a squib. When working on airbags, observe the...
Parts and assemblies of the rear side airbag 1. Nut: 9 Nm. 2. Side upholstery: With side airbag module. 3. Screws: 8 Nm. Replace after removal. 4. Rear side airbag: On the driver's side - with a squib. From the front passenger side - with a squib.
Removing and installing side airbag with side airbag igniter Remove the front seat and its backrest, Remove the upholstery and backrest cushion. Remove screw -2-. Move the side airbag -1- up and remove it from the backrest frame. Carefully detach the side airbag wiring harness...
Details and knots of the top pillow of safety 1. Lock bar: Prevents twisting. After installation, it should be visible along the entire length. 2. Top airbag: Driver's side - with a squib. From the front passenger side - with a squib. When working on the airbags,...
Details and assemblies of the airbag for legs 1. Airbag for legs with a squib. Any risk of mechanical damage to the surface of the leg airbag must be excluded. At the end of work, inspect the surface for damage, especially the perforated area. 2. Threaded...
Removal and installation of an airbag for legs with a squib Release screws -2-. Remove driver's foot airbag -1- towards rear. Disconnect connector -3- from igniter. To do this, unlock catch -4- with a small screwdriver -arrow- and unplug connector. Carefully! Lay the airbag...
Crash sensors for airbags — overview of installation locations 1. Crash sensor for front passenger side airbag: Installation location: in the door 2. Crash sensor for rear side airbag, front passenger side: Fitting location: under wheel housing trim. 3. Screw: 9 Nm 4. Screw: 9 Nm...
Removal and installation of sensors of blow of pillows of safety Removal and installation of the sensor of blow of a front airbag Attention! When working on airbags, observe the general safety regulations for handling the pyrotechnic modules for airbags, seat belt pretensioners and...
Details and knots of the block of management of pillows of safety 1. Airbag control unit -J234-: The ground connection of the control unit looks like its housing is connected to the body. Attention! After activation of the passive safety system, the control unit can continue to be...
Removing and installing airbag control unit -J234- Attention! When working on the airbag control unit, observe the general safety regulations for handling the pyrotechnic modules of the airbags, seat belt pretensioners and the battery disconnector. Remove the cover of...
Removing and installing the front panel 1. Front panel 2. Screw: Tightening torque: 1.5 Nm. Note: Disconnect the battery earth cable. Airbag assembly on the driver's side. Remove steering wheel. Remove steering column trim. Remove instrument cluster. Remove...
Removal and installation of a ware box from the driver's side Open glove box on driver's side -1- as far as possible in -arrow-. Detach glove compartment -1- by lifting, e.g. with a screwdriver, the stop on the front panel. Pull glove box -1- over stop and remove from dash panel...
Removal and installation of facing of a steering column Release the steering column adjustment lock lever. Pull out the steering column and press it down. Push cover -1- out of dash panel insert. Detach upper section of steering column trim -2-. Remove the top steering...
Removal and installation of the central tubular frame of the front panel Front Panel. Remove screw -2- (20 Nm). Remove the deflectors on the driver and front passenger sides. Unscrew the fixing screws of the switching unit from the central tubular frame and leave the switching unit in the...
Removal and installation of facing of a door of the driver Switch off the ignition and all electrical consumers. Remove trim -2- for electric window regulator and disconnect connectors -3 and 4-. Unclip trim -6- using wedge -T10383, 3409-. On the underside turn the nut -7- by...
Removal and installation of facing of a back door Switch off the ignition and all electrical consumers. Press trim -3- out with e.g. removal wedge -T10383, 3409- from the door trim panel. Remove screws -2- (4 Nm). Turn the nut -4- on the underside by 90°with a SW10...
Removal and installation of facing of a rack And Removal and installation of the top part of facing of a rack And Detach trim -1- from A-pillar. Slide trim up A-pillar and remove. Installation Insert the pillar trim first under the rib of the front panel. Press the...
Removal and installation of facing of a rack B Removal and installation of the top facing of a rack B Remove trim -2- with or without inscription "Airbag" (depending on configuration). Remove screw -3- (1.5 Nm). Detach trim -1- from wire at lower B-pillar trim. Pull...
Removal and installation of facing of a rack With Unclip front C-pillar trim -1- from rear door seal trim. Detach rear section from trunk lid seal. Detach trim from clips -2-. Slide the C-pillar trim guides out of the upper luggage compartment trim and remove the trim...
Removal and installation of facing of a rack D (Combi) Partially detach tailgate seal in area of D-pillar trim. Unlock latches of D-pillar trim -2- one by one. Release locks -3-. Slide trim off luggage compartment side trim and remove from vehicle. Installation Installation...
Removal and installation of facing of a cover of a luggage carrier Release screws -6- and remove locking clip -5-. Remove the rear window wiper motor cover. Unlock plastic clips -1- one by one. Remove trim -2- from door -7-. Installation Installation in reverse order. Note: Before...
Removal and installation of facing of back glass Unlock the fasteners on the edges of the door. Unlock the fasteners on the top edge of the door. Remove lining. Installation Insert cover at brake light frame -3-. Fix the frame at the top edge of the door. Insert the...
Removal and installation of lateral facing of a luggage compartment Removal and installation of the upper part of the side trim of the luggage compartment 1. The upper part of the trunk side trim. Removing: Remove wheel arch trim. Remove C-pillar trim. Release screw -1-. Detach trim...
Removal and installation of the lock of a back of a back seat Removal - lock in the upper part of the side lining of the luggage compartment Remove the upper section of the luggage compartment side trim. Remove cable -3- from bracket lever -1- in -direction of arrow A-. Scroll in...
Removal and installation of the ceiling panel Switch off the ignition and all electrical consumers. Remove sun visor. Remove upper A-pillar trim. Remove upper B-pillar trim. Remove C-pillar trim. Remove roof rails. Remove rear seat. Remove the rear seat back. Fold...
Removal and installation of noise insulation and roof reinforcements Remove ceiling panel. Cut soundproofing and roof reinforcements -1 and 2- with a carpet cutter into strips approx. 9 cm (pos. 3) - (hatching) -. Remove strips -3- from roof. Cut off adhesive residue -4-. Installation...
Removal and installation of a forward seat Set the seat using the longitudinal adjustment mechanism to the frontmost position. Release rear screws -1 to 3-. Move the seat using the longitudinal adjustment mechanism to the rearmost position. Remove front screws...
Removal and installation of front seat adjustments Removal and installation of the seat height adjustment lever Remove the front seat. Remove seat trim from door sill (height adjustable seat). Remove screws -1- (4.5 Nm) and remove lever -2-. Installation in reverse...
Removal and installation of a back of a forward seat Attention! Observe safety regulations when handling pyrotechnic components. Before starting work on pyrotechnic assemblies (e.g. by disconnecting the electrical connector) the mechanic must remove the electrostatic...
Removal and installation of a back seat Remove the covers for the ISOFIX child seat. First detach upper part -1-. Then detach the lower part -1- and pull it out of the eyelet -2-. Grasp the rear seat -1- from below with both hands in the area of the left and...
Upholstery and padding for front seats Removal and installation of an upholstery and stuffing of a pillow of a forward seat Remove the front seat. Remove the front seat belt buckle. Remove the seat cover from the tunnel side. Remove seat trim on door sill...
Upholstery and padding for rear seats Removal and installation of upholstery and seat padding Remove the seat. From the underside of the rear sofa along the entire perimeter, cut all the clamps for attaching the pillow - see. arrow-. Turn upholstery -1- all...