Ignition coils for «cylinders 2, 3 and 4»
Loosen clamps -1, 2- and remove air duct.
All
Disconnect connector -2-. Remove screw -1-.
Press puller -T10530- into hole in ignition coil -1- as far as it will go. Tighten nuts -2- in -direction of arrow-.
Remove spool with puller -T10530- in -direction of arrow- from camshaft housing.
Installation
Installation in reverse order. Loosely install all ignition coils in spark plug wells. Align the ignition coils with the connectors and connect all the connectors to the coils at the same time. Install the coils on the spark plugs, pressing them evenly with your hand (use of percussion instruments is prohibited).