Removal the knock sensor 1 «G61» (Skoda Octavia 5E)

Disconnect connector "2" from knock sensor 1 "G61". Remove the cooling system pump together with the thermostat.

Note: Knock sensor 1 "G61" is located under the intake manifold behind the coolant pump.

Note: Knock sensor 1 «G61» is located under the…

Unscrew the knock sensor 1 "G61" "arrow".

Installation

Installation in reverse order. Pay attention to the installation position of the knock sensor 1 "G61". Install the coolant pump together with the thermostat.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Supply system

Next ►

Removal and installation of ignition coils with power output stages
Ignition system — design description
Parts and assemblies of the middle and rear sections of the exhaust system…
Removal and installation the intake pipe
Front Exhaust System — General Installation Diagram

Removal and installation Hall sensors
Removal and installation the engine speed sensor «G28»

Read similar articles on other Skoda models

➧ Simos control unit, knock sensor I, camshaft position sensor Skoda Fabia 1 (1999-2007)
➧ Knock sensor 1, coolant temperature sensor Skoda Rapid 1 (2012-2022)
➧ Checking engine oil pressure and the corresponding sensor Skoda Superb 2 (2008-2015)
➧ Knock sensor (1.4TSI) — removal and installation Skoda Kodiaq 1 (2016-2024)
➧ Knock sensor #1, ECT sensor, ECM Skoda Yeti (2009-2017)
➧ Fuel level sensor — removal, installation and testing Skoda Favorit (1987-1994)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Octavia 3 (2013-2019)