Removing
1. Disconnect the wiring harness connector (2) from the air mass meter -G70- as shown in the figure below.
2. After loosening the spring clip shown in the figure below (1), remove the hose from the air filter.
3. Separate the clamps (3) and lay aside the vacuum hoses.
4. Unscrew the fastening screw on the air filter housing (arrow), shown in the figure below.
5. Disconnect the air intake pipe (4), as shown in the figure below.
6. Remove the filter housing assembly, carefully upwards.
Installation
1. Installation is made in reverse order to removal. Observe the following instructions:
drainage pipe (arrow) should be inserted between the gearbox and the body, as shown in the figure below.
Look under the fender to check if the drain pipe is properly installed.