1. Disconnect the sensor wiring connector, remove the nut (2 in illustration 5.5 Chapter 2) its fastening to the front suspension arm, unscrew the bolt (1) from the subframe and remove the sensor.
2. After installation, apply basic settings to the sensor using the diagnostic tool (see Chapter 5).
[Data copied from the portal: skodabook.ru]
Removal and installation the front suspension height sensor (Skoda Superb B6)
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article verified: Leonid Vladimirov
Read similar articles on other Skoda models
➧ Removal and installation the rear suspension height sensor Skoda Yeti (2009-2017)
➧ Rear left vehicle height sensor, Electronic damper control unit... Skoda Kodiaq 1 (2016-2024)
➧ Removal and installation the front seat side covers (seat with height… Skoda Rapid 1 (2012-2022)
➧ Removal and installation the seat belt height adjustment device Skoda Octavia 3 (2013-2019)
➧ Disconnecting and connecting the lower arm of the front suspension… Skoda Fabia 2 (2007-2014)
➧ Brake pedal installation height — adjustment Skoda Favorit (1987-1994)
Link to this article in various formats
Reviews and comments of visitors
No comments yet
- General information
- User manual
- Car driving
- Maintenance
- Power unit
- Petrol engines 3.6 l
- Petrol engines 1.4 l
- Petrol engines 1.8/2.0 l
- Diesel engines 2.0 l
- Diesel engines 1.9 l
- Cooling system
- Climate system
- Power and exhaust system
- Ignition and preheat system
- Launch and charge system
- Transmission
- Manual gearbox and clutch
- 7-speed DSG gearbox
- 6-speed DSG gearbox
- Transmission line
- Chassis (running gear)
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Lighting and signaling