Bottom lining (Skoda Octavia 5E)

Note: Depending on the engine version, slight differences must be taken into account during removal and installation.

Note: Depending on the engine version, slight…

1. Bottom trim. Removal: Unscrew nuts "8". Installation in reverse order.

2. Bottom lining. Removal: Remove the bee rivets "5". Unscrew the screws "7". Install in reverse order.

3. Bottom trim. Removal: Unscrew nuts "8", remove screws "7". Installation in reverse order.

4. Bottom lining. Removal: Remove the bee rivets "5". Unscrew the screws "7". Install in reverse order.

5. Expansion piston: To remove, push out the expansion pin

6. Clamping washer

7. Screw: Tightening torque: 1.5 Nm.

8. Nut: Tightening torque: 2 Nm

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Exterior (external elements)

Next ►

Soundproofing casing
Soundproofing of the water drainage box
Drainage box shield
Water drainage box casing
Removal and installation the wing holder

Parts and components — front tunnel crossmember
Removal and installation the rear tunnel crossmember
Hood — design description
Removal and installation the hood actuator
Removal and installation the pedestrian protection system loop

Read similar articles on other Skoda models

➧ Trunk lining Skoda Fabia 2 (2007-2014)
➧ Body dimensions of the body bottom Skoda Rapid 1 (2012-2022)
➧ View of the front part of the bottom Skoda Favorit (1987-1994)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors