Contents: Removal and installation the trunk…⬇ Installation ⬇ Removal and installation the trunk…⬇ Installation ⬇ Removal and installation the trunk…⬇ Removal and installation the shaped…⬇
Removal and installation the trunk side panel
Remove the trunk sill cover. Remove the rear seat back. Remove the upper panel (upholstery) of the C-pillar. Remove screws "4" (0.8 Nm). Using a lever motion, remove the cover on the retaining clip "8". After removing screw "9" (0.8 Nm), remove the retaining tongue "8". Remove the bee rivet "6". Remove screw "3" (10 Nm) of the tilt hanger "2". Remove the plastic cover "7". Remove nut "5" (2.5 Nm) securing the rear grouped light fixture. Press the trunk side panel "1" out of the clamps. Remove the tilt hanger "2". Disconnect the trunk light plug connector (left upholstery). The trunk side panel "1" should be removed from the vehicle.
Installation
Installation should be carried out in the reverse order of actions, and the following must be observed: Restore the position of the clamping clips in the bottom panel, if damaged, replace with new ones.
Removal and installation the trunk sill cover
Lift the trunk mat. Remove the spare tire. Remove the bee rivets "4". Loosen the nuts "3" (2.2 Nm). Remove the trunk sill trim "1" from the clamps "2" in an upward direction.
Installation
Installation should be carried out in the reverse order of actions, and the following must be observed: Restore the position of the clamping clips "2" in the trunk sill trim "1", if damaged, replace with new ones.
Removal and installation the trunk lid cover panel
Remove screw "4" (2.5 Nm) securing the lid pull handle "5". Remove the clamping clips "6". Remove the trunk lid cover panel "3". If removing the windshield wiper motor, remove the cover "1" and remove the screws "2" (1 Nm). Installation should be carried out in the reverse order of actions.
Removal and installation the shaped roof trim
Remove the upper panels (upholstery) of the A, B, C pillars. Remove the front ceiling light. Remove the glasses case. Remove the ceiling handrails. Remove sun visors. Remove the hold-down clips on the rear section of the headliner. With the front and rear seats folded down, remove the support from above the trunk. The shaped roof trim should be lowered downwards, using the "arrows" with the assistance of a second worker(danger of fracture) should be removed from the vehicle in the rear direction. Installation should be carried out in the reverse order of actions.
Source of the article web resource: SkodaBook.ru