Removal the front wing
Remove the front mudguard. Remove the foam part between the mudguard and the side member. Remove the soundproofing panel of the inner lining from the wheel well. Unscrew nut "2".
Disconnect the front fender liner clips "1" from the fender "3". Pull the inner trim "1" slightly forward at the bottom and lower it down. Unscrew the screws (3.5 Nm) "2" securing the bumper to the fender.
Unscrew nuts "6". Unscrew screws "2".
Note: There is no need to remove the bumper bracket "7".
Carefully remove wing "1".
Note: Start removing the wing at the A-pillar and finish at the bumper.
Installing the front wing
Wing "1" is installed in the reverse order. Tightening torque of screws is 2-8 Nm. Pay attention to parallelism and correct gaps. Fitting should be done with the wing holder loosened.
Note: Install wing "1" without tension or distortion.