Press the spoiler even harder and remove the shaped seal "1" from the fasteners upwards.
Remove the screws on the left and right. Pull the spoiler out of the holder forward and lift it up.
 |
 |
Installation
Insert spring "1" into the spoiler.
 |
 |
Insert the spoiler with spring "1" back into the holder.
Tighten screws "2" to the specified tightening torque.
Align the shaped seal "1" in the center / press it against the stop "arrow".
Note: The shaped seal must be pressed against the stop, otherwise it will ripple when inserted into the frame.