Remove the back cover "1" in the direction of the "arrow".
Unscrew screws "2" of handle "1".
Remove rear screws "2" of sunroof curtain "1".
Raise the rear edge of the sliding sunroof curtain "1" as shown in the figure, and remove the support with the runners back along the "arrow" from the guide.
Raise the curtain with the support.
Remove the left and right sliding runners "1" from the support "2".
Pull the curtain fabric out of the support to the side.
Installation of the support
Installation in reverse order. Carefully insert curtain fabric "1" into support "2".
Insert runners "1" into the support.
Caution! The inserted runner should not rub against the rubber buffer "arrow".
Installing a sliding sunroof curtain
The support is inserted into the hatch curtain.
Note: Before installing the runner in the guide, slightly extend the guide pins from the rear side in the direction of the "arrow".
Insert the curtain with runners into the guides.
Caution! The runners and their rollers must move correctly in the guides.
For clarity, the runner is shown in the figure without a guide.
Insert the leash "2" into the guide "3" as shown in the picture. The runners "1" are put on the guide "2" from above. The leash "2" when correctly installed should catch on the runner-1-.
The curtain centralizers "1" must be inserted from above into the guides "arrow" on both sides.
