Removing the top seal
The glass cover has been removed.
1. Top seal.
Pull the seal up around the entire perimeter of the sealing channel.
Installing the top seal
Insert the sealant into the sealing channel with the sealing lip outward.
Align the seal so that the joint -arrow- is centered at the rear and insert it into the seal channel.
Fill the seal around the entire perimeter.
Carefully! Do not stretch the seal, otherwise it will not refuel completely.
Replacing the glass lid seal
Open the sliding sunroof. Remove the rear seal of the glass cover from the seal channel.
Installation
Note: Moisten the seal with e.g. soapy water to facilitate installation.
Fit sealant -1- on both sides flush with glass.
Insert the seal into the channel as shown in the figure.
Fill the seal completely on both sides in the direction from the edges to the middle.