Note: To ensure normal operation of the sunroof drive, it is necessary to adapt it after removing and installing the electric motor.
1. Frame of the lift-and-slide hatch
2. Seal
3. Front pad
4. Facing
5. Screw: 2 Nm
6. Screw: 3 Nm
7. Electric motor (sliding sunroof control unit -J245-). After replacing the electric motor, it is necessary to perform coding in the Guided Functions of the Guided Fault Finding
Data Copied from the portal: SKODABOOK.ru
8. Drainage hose
9. Screw: 3.5 Nm
10. Toggle mechanism guide frame: With toggle mechanism guide and cables.
11. Wiring harness
12. Screw: 3.5 Nm. Observe the sequence of installing the screws. Tighten the front screws first on the right, then on the left. Tighten the rear screws first on the right, then on the left.