Caution! Observe general safety rules when handling pyrotechnic airbag modules, seat belt pretensioners and battery disconnect device. Observe special instructions for driver and front passenger airbags. Electrostatic discharge can cause airbags to deploy. Therefore, before disconnecting the activation and ground wires, you must discharge the electrostatic charge from yourself. To do this, you can, for example, touch the body or the door lock pawl with your hand.
Disconnect the battery terminals. Remove the glove box on the front passenger side from the dashboard together with the bracket. Disconnect connector "4" of the squib 1 of the front passenger airbag.
 |
 |
To do this, unlock the lock "2" with a small "arrow" screwdriver and disconnect the connector "1".
Remove screws "2" (7 Nm) and "3" (7 Nm). Remove the front passenger airbag module "1" downwards.
The original can be viewed on: skodabook.ru
Caution: Place the airbag module with the soft side facing up.
Installation
Installation in reverse order.
Note: Check that the connector is securely connected and clicks into place with an audible click. Make sure that the wires are not pinched anywhere.
Connect connector "1" to the airbag squib "arrow a". Press the connector lock "2" in the direction of "arrow B", thus bringing the connector to the stop and simultaneously fixing it in the squib.
Note: Before screwing in the screws, be sure to clean the threads of the screws themselves and their nuts in the front panel.
Turn on the ignition. Connect the battery terminals.
Removal and installation the switch with a lock to disable the front passenger airbag
Attention! When working with airbags, observe the general safety rules for handling pyrotechnic airbag modules, seat belt pretensioners and battery disconnect devices.
Turn off the ignition. Remove the glove box on the front passenger side from the dashboard together with the bracket. Press the lock "1" in the direction of the "arrow" to unlock the connector. Disconnect the connector "2". Unlock the spring latches "3" and "5". Push the switch "4" out of the housing.
Installation
Note: Check that the connector is securely connected and clicks into place with an audible click. Make sure that the wires are not pinched anywhere.
Check that the switch is locked into the housing with an audible click.