Attention! When working on airbags, observe the general safety regulations for handling the pyrotechnic modules for airbags, seat belt pretensioners and the battery disconnector.
Remove the airbag assembly on the driver's side.
Equipment variant: multifunction steering wheel
Unlock catch -2- with a small screwdriver -arrow- and disconnect connector -1- from driver's airbag igniter.
Disconnect wiring harness connector -1-. Release the wiring harness from the mountings and remove it from the driver's airbag -2-.
Installation
Connect connector -1- to airbag igniter -arrow a-. Press the latch -2- of the connector in the direction of -arrow B-, in this case the connector is brought to the stop and at the same time is fixed in the igniter.
Installation in reverse order.
Instruction. Check that the connectors are well connected and lock into place with an audible click. Make sure that the wires are not pinched anywhere.