Removal and installation the lower support of the power unit
Remove the noise-insulating casing. Unscrew screws -1, 2, 3- and remove the lower support of the power unit.
Installation in reverse order.
Checking the position of the power unit supports
The following dimensions must be ensured: between engine support "2" and engine bracket "1" there must be a distance "a" = 10 mm. The edge of the cast bracket of engine support "2" must be parallel to console "1". Dimension -b-=dimension -b--.
Note: Distance "a" = 10 mm can also be checked using a suitable rod.
If measurements show that the gap is too small or too large, adjust the powertrain mounts.