Note: The neutralizer is removed together with the exhaust pipe. All cable ties must be installed in their original places during assembly.
Remove connectors "1" and "2" from the bracket and disconnect them. Hang the wires.
Unscrew screw "2" and remove the screw clamp. Unscrew screw "1", unscrew the nuts "arrows".
Unscrew the bracket "arrow" screws. Remove the tunnel cross member.
Loosen screws "1" and remove the heat shield of the propeller shaft on the right side, if present. Remove the plastic cover of the floor tunnel.
Unscrew the "arrow" screws. Remove the electrical connector from the bracket, release the electrical wire to the lambda probe from the fasteners.
Information published on the website skodabook.ru
Release and move the "arrow" coupling back. Remove the neutralizer assembly with the inlet pipe by moving it backwards.
Note: The bellows of the exhaust pipe must not be bent more than 10°, otherwise it may be damaged. Do not pull the bellows of the exhaust pipe too hard, so as not to bend it. Do not damage the bellows. Install the transport protection "T10403" on the bellows.
Insert screwdriver "2" into the slot "arrow" of the turbocharger and, having hooked it, remove the sealing ring "1".
Installation
Installation in reverse order.
Note: Replace the sealing gasket and self-locking nuts.
Lubricate the studs and screws of the neutralizer with high-temperature paste. Adjust the position of the exhaust system components (install without stress).
Torque and sequence of tightening the neutralizer
Torque and sequence of tightening the neutralizer
