Contents: Removal ⬇ Installation ⬇
Removal
To remove the 2nd, 3rd or 4th ignition coil
1. Loosen the mounting clamps (1) and (2), then remove the intake air duct as shown in the figure below.
Continued for all ignition coils
2. Disconnect the wiring harness connector (2) shown in the figure below.
3. Unscrew the mounting bolt (1) shown in the figure below.
4. Press the puller (T10530) into the hole in the ignition coil housing (1) until it stops, as shown in the figure below.
5. Tighten the fastening nuts (2) in the direction of the arrow as shown in the figure below.
6. Remove the ignition coil from the cylinder head using the previously installed puller, pulling it in the direction of the arrow, as shown in the figure below.
Text taken from this website: SkodaBook.ru
Installation
Installation is carried out in the reverse order of removal.
1. Install all ignition coils first onto the spark plug terminals.
2. Align the ignition coils with the connectors and simultaneously connect all connectors to the ignition coils.
3. Press the ignition coils towards the spark plugs by hand. Install and tighten the ignition coil mounting screws to a torque of 8 Nm.