Contents: Removal ⬇ Installation ⬇
Note.
- Necessary special devices, control and measuring instruments, as well as auxiliary means:
- Assembly tool "T10118".
- Puller "T10094A".
Removal
1. Install the "T10094A" puller on the ignition coil with the final power stage in the direction of the arrow, as shown in the figure below.
2. Slightly remove the ignition coil with the final power stage
3. Install the installation tool "T10118" as shown in the figure below.
4. Carefully release the wiring harness connector retainer and disconnect the wiring harness connector.
Installation
1. Install the "T10094A" puller on the ignition coil with the final power stage.
2. Connect the wiring harness connector to the ignition coil with the final power stage so that it clicks into the locked position.
3. Press the ignition coil with the final power stage onto the spark plug in the cylinder head using the T10094A puller.